HEATIT HISD 6-feet Pipe Heating Cable with with Built-in Thermostat Black B01GYGGLRO

  • Model: B01GYGGLRO
  • 505 Units in Stock
Color:
    • HEATIT HISD 6-feet Pipe Heating Cable with with Built-in Thermostat Black B01GYGGLRO
    • Plumb Pak K857-20 Clip on Deep Flange Cover for 1 2 in. Copper Pipe Chrome B07MQY3CSC
    • EVERCONNECT 4824 Flexible Pvc Rubber Coupling with Stainless Steel Clamps 1.5 inch Black B00HZSD7JQ
    • 10-pk Pex 3 4 Female Sweat x 3 4 Pex Barb Adapter- Sweats Over Copper Tube B07FN1K4KF
    • IBEUTES 10-Pack Black 1 2X 1.2” Malleable Iron Cast Pipe Fitting Nipple 1 2 Inch - Threaded Pipe Nipples For DIY Decor Or Industrial Vintage Style B07MTCP95B
    • Brooklyn Pipe 3 4 Inch Elbow Tee Combo Pack 10 Elbows 10 Tees Threaded Pipe 90 Degree Pipe Elbow Tee | Decorative Iron Piping Metal Cast Pipe Fittings For DIY Furniture Projects B07F36Y6C5

$76.27  $19.90
Save: 74% off

Add to Cart:
HEATIT HISD 6-feet Pipe Heating Cable with with Built-in Thermostat Black B01GYGGLRO

This fits your .

  • Make sure this fits by entering your model number.

  • Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two year limited quality . If you are not completely satisfied with HEATIT heating cable, please don't hesitate to contact our customer service in any time, we'll try our best to solve your issues.

  • Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 68F on39F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid.

  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket.

  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight.

  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don't plug in the cable for a long time for testing. When you feel the slight warm, please turn it off.

  • Copper

  • HEATIT HISD 6-feet Pipe Heating Cable with with Built-in Thermostat Black B01GYGGLRO


    button-top.png